| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Laser Engraving & Cutting Machines Discuss CNC Laser cutting machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-28-2008, 07:37 AM
| |||
| |||
Ok, sorry to keep filling up the forums with my problems but I don't know where else to ask. So, after I've updated to the 4.1.2.0 firmware (MPC 6515 controller) and LaserCut 5.3 I had that weird problem with the laser not firing up. Following your advice I've reinstalled the LaserCut 5.1 software and the 4.1.0.18 firmware. Now, I have a different problem. The laser just burns a small part of the graphic and it stops moving and firing but the timer on the pad continues to run as if nothing happened. Please help me. Controller type MPC6515 DLL Version 4.1.2.0 Firmware version 4.1.0.18 Hardware Version 3.0.0.6 USB firmware 1.0.0.11  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trade offs between Moving Gantry and Moving Table | gregmary | DIY-CNC Router Table Machines | 11 | 04-22-2011 01:48 PM |
| Moving my Rabbit Laser from EU to Canada - Import regulations? | glintid | Laser Engraving & Cutting Machines | 1 | 05-20-2008 10:00 AM |
| Discussion of moving table vs moving gantry | rkremser | DIY-CNC Router Table Machines | 5 | 02-20-2008 03:59 PM |
| I put Carriage stops / E-stops on the x&y Shoptask 1739 Gunmaster....I was bored lol | spunky1974 | Shopmaster/Shoptask | 0 | 06-30-2007 04:13 PM |
| Moving Table vs Moving Gantry; Dremel vs Router | chuckknigh | DIY-CNC Router Table Machines | 32 | 03-27-2007 08:48 PM |
| | |
Linear Mode
