How to wire in pot - CNCzone.com-The Largest Machinist Community on the net!

chippypah · #1 06-23-2011, 02:37 AM

Hi All,
Can anybody give me the information on how to wire in a pot, to adjust the power on my laser.
Cheers
Pete

Tweakie · #2 06-23-2011, 12:06 PM

If you have a similar PSU to mine then the pot connects like this.

Tweakie.

chippypah · #3 06-24-2011, 02:37 AM

Thanks for that.
Cheers
Pete

rcpilot82 · #4 06-29-2011, 10:40 AM

This may be a dumb question, but why would you want a manual setting whe you can set it up in the program (lasercut)? is there a better benifit?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mitsubishi wire type setting for zinc coated wire	Futurewire	EDM Machines	1	01-26-2011 03:47 AM
Mitsubishi wire type setting for zinc coated wire	Futurewire	EDM Machines	2	01-25-2011 06:49 AM
Running stepper motor wire with router wire?	basskitcase	DIY-CNC Router Table Machines	2	02-19-2010 10:18 AM
I have 6 wire motors can I use a 4 wire driver	Musick7	Stepper Motors and Drives	10	05-05-2009 10:39 PM
power supply size? for multi wire (total 250 inches of wire)	DanOSB	CNC Wire Foam Cutter Machines	5	03-02-2009 04:34 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)