Ooops ! - CNCzone.com-The Largest Machinist Community on the net!

Tweakie · #1 05-24-2011, 04:18 AM

Ooops indeed.

Tweakie.

zax15uk · #2 05-24-2011, 04:01 PM

Yes, oops! Not good.

Was it mechanical damage (impact) or a result of local overheating due to insufficient coolant flow and/or trapped air?

Zax.

Ken_Shea · #3 05-24-2011, 05:01 PM

That is a bummer.
What was the cause?

Any coolant get into the electronic components?

Tweakie · #4 05-25-2011, 12:30 AM

Hi Guys,

I bought the machine in that condition.

It had an HT fault and I suspect that the service engineer tried to remove the board without first disconnecting the HT cable.

There is no coolant in the part with the electrodes so no water damage - fortunate really.

Tweakie.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to find local machines shops? 'Ooops I meant "machine guys")	FXC	DIY-CNC Router Table Machines	3	11-22-2009 09:09 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)