My Synrad Laser Controller.

[Tweakie]

Towards the end of last year I decided to construct a controller for my Synrad RF laser as an alternative to using the UC2000. Nothing High-Tec just real basic stuff. Extensive testing over the winter months has shown that the MKI is now ‘good to go’ and so far at least 3 other units have been built, by others, in different parts of the world, with no bad reports having been received so far.
This is an ‘open source’ project and still has some way to go before it is finalised but full constructional details of the prototype including the pcb isolation routing GCode and PIC hex files are available on my website here. *RF Laser

Tweakie.

[cinematic2]

Hi Tweakie
Don`t have one controller for sell?
Mayby you can make next one better and sell this one :-)

Regards
Wojciech

[Tweakie]

Hi Wojciech,

I went to all this trouble especially for you, so that you could make your own controller

Tweakie.

[Tweakie]

The enclosure for this little project has now been completed.

Tweakie.

[zax15uk]

Nice job Tweakie, that's very slick.

Zax.

[Tweakie]

Thanks Zax.

A 1 second blast at 20.5% (no lens, beam diameter approx. 6mm on target at 450mm from laser) just for fun.

Tweakie.