Software question:

[Lasertag]

I am currently using "laser engraved 5.3" and I'm not thrilled with it. What other software should I look into?

Thanks for any help.

[bpoulin]

I'm looking too, haven't found much. What are you using for your design software? I like adobe illustrator, and others like Corel Draw, then we just use LC5.3 for the output.

[Lasertag]

The interface between corel and lasercut seems poor.

[bpoulin]

just export or save it as .ai 8.0 version, LC will tell you it can't open it, but then it'll open it. Then import it into LC.

[Lasertag]

Thanks for the info. I'm going to keep looking for something other than lasercut. If you come across something good, don't hesitate to post!

Thanks again.

[bpoulin]

You do the same, I would like to find a software drop in replacement that doesn't require replacing hardware.

[Lasertag]

Will do.