"Parker Daedal" mirror - replacement advice?

Results 1 to 2 of 2

Thread: "Parker Daedal" mirror - replacement advice?

  1. #1
    Registered
    Join Date
    Feb 2010
    Location
    USA
    Posts
    58
    Downloads
    0
    Uploads
    0

    Default "Parker Daedal" mirror - replacement advice?

    I've got a couple of these on a table with a 100W C02 tube, one has deteriorated significantly ..

    Other than it saying Parker Automation Daedal Division on it I don't see any kind of identifier.

    This is used in the beam directional path.

    Could I get a 25mm mirror such as the one below and mount it in place of the peeled one? .. or even directly on top of it?

    25 mm Molybdenum (MO) Reflection Mirror

    "Parker Daedal" mirror - replacement advice?-img_3096-jpg

    Similar Threads:


  2. #2
    Registered
    Join Date
    Feb 2010
    Location
    USA
    Posts
    58
    Downloads
    0
    Uploads
    0

    Default Re: "Parker Daedal" mirror - replacement advice?

    After looking at this mirror in different lighting, it appears that this peeling area is some kind of coating that maybe should have been taken off?

    The perimeter border area has always been the different color, giving the impression that a mirror was embedded in the surface. However looking closer at the areas where it peeled, it's revealing a constant surface below that is consistent with the edges.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

"Parker Daedal" mirror - replacement advice?

"Parker Daedal" mirror - replacement advice?