Does this look right? (laser tube high voltage pin)

Results 1 to 1 of 1

Thread: Does this look right? (laser tube high voltage pin)

  1. #1
    Member
    Join Date
    May 2007
    Location
    USA
    Posts
    111
    Downloads
    0
    Uploads
    0

    Default Does this look right? (laser tube high voltage pin)

    Ive been having problems with my laser for a while it puts out just a little beam just strong enough to discolor wood. I put a meter on it and get 4 mililamps no matter what the input control voltage is going to psu. I finally pulled the high voltage tape off of the input to the laser. it is a slip on fitting and this is the color of the pin. Its a darkgrey to light black color. Is that the color it is supposed to be?

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Does this look right? (laser tube high voltage pin)-20140918_175655-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Does this look right? (laser tube high voltage pin)

Does this look right? (laser tube high voltage pin)