- Need Help!- Help with which software I can use
-
Registered
Help with which software I can use
NEWBIE, I bought an 2002, laser table CAMTECH Laser Master, 10' x 5' table.
The PC crashed, and I had to get a new $~2500 PC from WINCNC, with the controller card, Now I have a problem because I don't have COREL, and TPCWIN, but did get a copy of the old PhotoGrav software, which can not run on the new 64bit PC.
I'm lost, Can I use some third party software, which is free or cheap, which the WINcnc?
Similar Threads:
-
- Need Help!- Help with which software I can use
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules