Need Help! 60W Chinese Laser tube blown


Results 1 to 4 of 4

Thread: 60W Chinese Laser tube blown

  1. #1
    Registered
    Join Date
    Oct 2016
    Location
    United States
    Posts
    1
    Downloads
    0
    Uploads
    0

    Angry 60W Chinese Laser tube blown

    Hi everyone ... I'm new here, in need of some help. I have a 60W Chinese/Redsail look-a-like machine (off eBay!!) that's been in use for less than a year ... I was cutting acrylic today and there was a loud 'pop' from the machine, followed by no cutting progress. I paused and checked, and found the end of the CO2 tube had broken off ... don't know if it was an overheat, or it just wore out ... But I need to get it going again. Any suggestions on a better replacement unit? I'm in the USA. and any other advice totally welcomed too! I've been scanning the forum, a little overwhelmed with the amount of info!!!

    Similar Threads:
    Attached Thumbnails Attached Thumbnails 60W Chinese Laser tube blown-img_1323-jpg  


  2. #2
    Member
    Join Date
    Nov 2008
    Location
    USA
    Posts
    644
    Downloads
    0
    Uploads
    0

    Default Re: 60W Chinese Laser tube blown



  3. #3
    Registered SPT-Laser's Avatar
    Join Date
    Aug 2016
    Location
    China
    Posts
    45
    Downloads
    0
    Uploads
    0

    Default Re: 60W Chinese Laser tube blown

    Hello,

    This is Emily from SPT laser, CO2 laser tube manufacturer.

    If the tube end is broken, just get a replace the broken tube and get a new tube.

    60w machine, your tube length is 1200mm or 1250mm?

    60W Chinese Laser tube blown-c-series-laser-tube-jpg

    Kind Regards

    Emily

    Email: marketing@laserwd.com



  4. #4
    Registered
    Join Date
    Aug 2007
    Location
    US
    Posts
    9
    Downloads
    0
    Uploads
    0

    Default Re: 60W Chinese Laser tube blown

    Check out LightObject. Marco has reasonably priced tubes and great customer service. Problem may have started in the power supply so check that out also. May need one of those as well.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

60W Chinese Laser tube blown

60W Chinese Laser tube blown