Problems- Artcam Pro to starcam has Larken nc export
has Larken_in *.nc toolpath creation does not work properly says i???
need help with Artcam to print on my Larken 50
cannot import it to starcam what other methods are availabe in starcam/artcam
please help... also have profilelab 3d this works well with starcam so if there was a way to put artcam file to profilelab the to starcam i'd be happy with that>?
i found to export as gcode .tap in Artcam and rename it .nc and import gcode command in starcam works well!!! found a solution should post it on your website!!!
Good, you figured it out. The tap file is a gcode, just with a different extension.
I'm planning to have an updated chip for the starcam board by the fall, that will add a bunch of features.
I will post in this forum when its ready.