Problem- Problems- Artcam Pro to starcam has Larken nc export

[schoolboyeric]

has Larken_in *.nc toolpath creation does not work properly says i???
need help with Artcam to print on my Larken 50
cannot import it to starcam what other methods are availabe in starcam/artcam
please help... also have profilelab 3d this works well with starcam so if there was a way to put artcam file to profilelab the to starcam i'd be happy with that>?

[schoolboyeric]

i found to export as gcode .tap in Artcam and rename it .nc and import gcode command in starcam works well!!! found a solution should post it on your website!!!

[schoolboyeric]

actually Larken program fully supports .tap as an output???? because i am having problems with starcam 1.91

[schoolboyeric]

see attached for file how do you open it???? starcam displays nothing when renamed to .nc

[Larken]

Good, you figured it out. The tap file is a gcode, just with a different extension.
I'm planning to have an updated chip for the starcam board by the fall, that will add a bunch of features.
I will post in this forum when its ready.

Larry K