NEED BRAKE SOLENOID ON KNEE MILL - CNCzone.com-The Largest Machinist Community on the net!

1FAST432 · #1 12-03-2007, 02:40 AM

Looking for a replacement solenoid for air brake on older cnc knee mill.Can't seem to find anything on the net. If anyones replaced one please let me know where you found it. THANKS 1FAST432

unterhaus · #2 12-03-2007, 09:43 AM

you need the air solenoid? Do you have the old one? The one on my bridgeport seemed like a fairly standard part. I didn't really want to have the air driven brake, so it's in a box somewhere.

1FAST432 · #3 12-03-2007, 01:26 PM

Yes,I need the air solenoid. The old one is a Kuroda ,hard to make out numbers but looks like AC200/220 volt. Can't make out anything else,looks original . Let me know,my email address is JBPOLARIS1@hotmail.com. THANKS FOR THE REPLY !!!

peternielsen · #4 12-04-2007, 12:24 AM

most fluid power companies can supply you with a suitable solinoid.
The most important are the coil voltages and port size.
220 volt is very common

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
knee mill vs bed mill, brimingham, enco, jet other	allenpnx	Knee Vertical Mills	4	12-18-2007 09:56 PM
IH vs Knee Mill	HimyKabibble	Industrial Hobbies (Support forum)	4	11-14-2007 04:47 AM
Knee Mill vs Square Column Mill	HimyKabibble	Bridgeport and Hardinge Mills	0	11-09-2007 07:27 PM
knee on mill will not go up	shannon carson	Bridgeport and Hardinge Mills	7	08-16-2007 03:50 PM
Need advice on a new knee Mill	mikesos1	Knee Vertical Mills	16	03-24-2006 05:25 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)