Hello,

i am about to refurbish an older Iberimex (lagun) FTV2-mill, and i need to repair the power-feeds, too.

https://www.dropbox.com/s/nqljuizo3v...Feed_Lagun.jpg

As i am from germany i can't just send the feeds and/or circuit boards to USA, so i had a look on it myself.
Man, i am scared^^

Are there any kind of schematics for this old power-feeds? If so, can someone please send me them? Also, ANY kind of schematic for similar products, diagram, documentation or else would be appreciated!
servus444(at)arcor.de

I do not have any schematic for this units and they are connected to the control enclosure with 18-pole cables. And there the horror starts, but have a look on your own...

https://www.dropbox.com/sh/ewrys9y87ratbde/rP3yWQ3mvR


As you can see, there is not ANY chance to get through this without any written help^^
Best would be, if i could throw all that stuff away and just use the feeds on their own. No limit switches, no extras, just the motors, direction handles and potentiometers.

These are type 90 servo-products-feeds, btw

If i could find out what needs to be connected where on the lower end of the feeds, would be fine.

Maybe someone can help me with this odyssey?


Thank you very much and best regards,

Marc Hafke

Similar Threads: