Kitamura Mycenter H400

[tushar]

Hello I hope you have overcome the problem.
I am facing the same problem i.e pallet changing arm not moving.
I am not sure or am having a doubt that I am not setting the data for arm forward & reverse position at the proper place.
Can you help me

[stucaruk]

Give the Kitamura guys a call with the machine serial number (847) 520-7755

They will help you out and are aewsome. I recently had an issue where my pallet changer would hang and found the limit switch was stuck becasue of all the coolant and crud that had acumulated around it.

It was simple for the tech to wlak me through the ladder and verify the actual status of the appropriatte bits, and decide what was wrong. Then I simply had to go digging for the switch. A bit of WD40 and some light prying on the switch and all was good to go. By the way, the switch was stuck in and there was no room to pop it out so I lightly pushed it further in and the spring and WD 40 allowed it to come back out. After a few cycles it worked just fine, and has for several months since then.

Kitamura tech support is first rate, and they don't seem to care how old the machine is or how you acquired it. Best of all it's free!

Stu