Results 1 to 2 of 2

Thread: transfer program from pc to mycenta 6M controller

  1. 02-16-2012, 01:11 PM #1
    handyholmes
    handyholmes is offline
    Registered
    Join Date
    Jan 2009
    Location
    us
    Posts
    2
    Downloads
    0
    Uploads
    0

    transfer program from pc to mycenta 6M controller

    How do I set-up 6M Controller and Mastercam X5 to transfer programs. I have RS232 interface cable w/ 25pin connector. IE, What is correct buad rate ?

  3. 02-16-2012, 04:48 PM #2
    dcoupar
    dcoupar is offline
    Registered dcoupar's Avatar
    Join Date
    Mar 2003
    Location
    USA
    Posts
    2,504
    Downloads
    0
    Uploads
    0
    Here's some information for you:

    Fanuc RS232 Fanuc 6 serial communication setup

« parts counter | I got a new to me Mycenter 4 »

Similar Threads

  1. How to transfer program between CNCs
    By nedkelly348 in forum Machine Problems, Solutions , Wireless DNC, serial port
    Replies: 15
    Last Post: 03-26-2010, 02:26 PM
  2. Mazak Program Transfer
    By Mark18969 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 14
    Last Post: 11-09-2009, 05:06 PM
  3. program transfer between CNC and PC
    By sinha_nsit in forum Fanuc
    Replies: 10
    Last Post: 08-01-2009, 06:03 AM
  4. NC Transfer Program
    By JamesBond in forum General CAM Discussion
    Replies: 69
    Last Post: 04-07-2009, 07:40 PM
  5. transfer of program
    By Dar in forum Bridgeport and Hardinge Mills
    Replies: 10
    Last Post: 09-13-2007, 10:43 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.