Kiatmura Jig 7 Unclamp Cylinder - CNCzone.com-The Largest Machinist Community on the net!

tahlinc · #1 05-04-2011, 08:35 AM

Cylinder is not pushing drawbar far enough release pull stud.
Construction of cylinder reveals that it is an air oil force multiplier. Perhaps oil is low so it does not develop full travel.
Any ideas on adding oil?

Thanks,
Jim

tahlinc · #2 11-19-2011, 08:07 AM

There should be a plastic line that comes down from the top left of the head stock to a fitting on the side of the cylinder.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- unclamp pallet for FH-5800	sting_dot	Mazak, Mitsubishi, Mazatrol	3	06-21-2011 08:31 PM
ST 20 - C axis unclamp	SurfRunner	Haas Lathes	2	03-07-2011 10:31 AM
Need Help!- Clamp Unclamp Problem VMC	24kilo	Fanuc	7	01-18-2010 04:44 PM
Tool unclamp fault	IMlearnin	Daewoo/Doosan	2	06-07-2007 08:40 PM
compressor piston cylinder compared to an IC engine piston cylinder	CNCnUtZ	I.C. Engines	1	12-28-2003 07:06 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)