kcam steps in 1 dir

[grumpy1]

been playing with bunch of diff controllers
and software to run 4 axes mill.
win2000 system 450mhz 300meg ram
now trying kcam, getting 1 dir
tried diff configs for ports only 1 way works,but only in 1 dir.
using cmd260's at 35 v 5v opto in
any settings on the cmd side I may be missing
Thanks
Grumpy1

PS system needs to stay networked to other controllers

[balsaman]

I would look at the direction pin for the axis and make sure it is set correctly. Each axis needs a step and direction pin to operate in two directions.

Eric