It's Smaller Than It Should Be!! - CNCzone.com-The Largest Machinist Community on the net!

SIMONSIGNS · #1 06-05-2005, 06:30 PM

Hi I'm using Kellycam and drew up some text, sent it to the machine it comes out about 1 inch high, when I originally drew it at 12 inches high....... I guess its a servo motor setting somewhere? maybe someone smarter than me can point me in the right direction!....thanks!

abasir · #2 06-05-2005, 08:29 PM

Go to Option > Table Setup and make sure it match your actual setup

SIMONSIGNS · #3 06-06-2005, 03:05 AM

thanks for your help.......

ynneb · #4 06-06-2005, 05:18 AM

It's Smaller Than It Should Be!!

Try Viagra.

cbass · #5 06-06-2005, 06:32 AM

Originally Posted by ynneb

Try Viagra.

Maybe it was the cold water

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Smaller Spindles?	spoiledbrat	Commercial CNC Wood Routers	6	03-24-2006 11:53 PM
Anyone hazzard a guess at the VA rating of this transformer.	MrBean	General Electronics Discussion	4	02-11-2005 07:03 PM
How to weld plate to tube at 90 degrees?	coolman	Welding, Brazing, Soldering, Sealing	12	12-23-2004 03:03 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)