Results 1 to 1 of 1

Thread: 1st real 3D CNC routing

  1. 05-16-2009, 10:36 AM #1
    Wood Chuck 59
    Wood Chuck 59 is offline
    Registered
    Join Date
    May 2008
    Location
    USA
    Posts
    25
    Downloads
    0
    Uploads
    0

    1st real 3D CNC routing

    I finally got around to programing & cutting some real 3D features. Kiya is my dog's name. Thanks to Ron Liboon at K2 for helping me get the Mach3 program to run long files. I used a 1/4" ball endmill, with .040" step over.
    WoodChuck59
    Attached Thumbnails Attached Thumbnails 1st real 3D CNC routing-im003161.jpg   1st real 3D CNC routing-im003162.jpg  

« 9850 machine | Bosch Mount using K2 »

Similar Threads

  1. A real newbie here
    By yakima rc racer in forum DIY CNC Router Table Machines
    Replies: 0
    Last Post: 11-11-2008, 10:22 PM
  2. real noob here just a few Q`s if I may
    By stk2008 in forum General Electronics Discussion
    Replies: 4
    Last Post: 03-22-2007, 06:46 PM
  3. Real, real newbie!!!
    By aggie_67 in forum General CAM Discussion
    Replies: 11
    Last Post: 02-04-2006, 01:10 AM
  4. 80/20 Is this for real?
    By Chunky in forum Linear and Rotary Motion
    Replies: 1
    Last Post: 06-03-2005, 03:10 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.