Need Help! Anybody Home at K2? - CNCzone.com-The Largest Machinist Community on the net!

SPEEDRE · #1 05-29-2008, 09:18 AM

I've been trying to contact these people by email and phone to no avail. IS ANYBODY HOME AT K2CNC???????????

Mike Stevenson · #2 05-29-2008, 02:21 PM

SPEEDRE,

I noticed you posted at 6:18 AM. K2CNC does not open until 9:00 AM. Call this number and you should have no problem: 714-999-1156.

SPEEDRE · #3 05-29-2008, 02:52 PM

That's not Eastern Std. Time. I'm generaly fast asleep at that time. I should try maybe at 1:00 p.m. EST, Thanks. I need a wiring diagram and some motor info.

Mike Stevenson · #4 06-06-2008, 07:16 PM

SPEEDRE,

Did you get through to K2 Devices yet?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Home again Home again Jiggety Jig. Well Not Just Yet!	Mr.Chips	DIY-CNC Router Table Machines	10	03-18-2008 09:58 PM
home	frankg521	Mach Mill	0	07-18-2007 01:13 PM
Fab@Home	lostbaka	Suggestions for the CNCzone.com site.	2	12-03-2006 09:40 PM
Anyone Home?	Switcher	Forum Questions or Problems	3	11-13-2006 09:56 AM
Home/G28	Ken_Shea	Haas Mills	2	08-15-2003 12:51 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)