Thank you for taking the time to post this. I bought one of these machines recently and have had no way to verify if the settings are correct or not. Im going to reference your settings when im trouble shooting. Thank you again
Hi
Here is my story
Several years ago I bought a used KG-4925 and was pleased with the results.
But a few years later someone broke into my shop and stole all my small hand tools and the PC for the K2 router.
I Contacted K2 and bought a new PC for it. It came unconfigured and when I tried to contact them I found out they were out of business.
After several months of research I finally got it going. I think it is correct as my CNC router is now working.
Recently I received a request for help. So I thought it would be good for me to share my configuration. (see attachment at the bottom of this post)
One key point was the 5Volts cable was not connected properly.
If anyone has any documentation for K2CNC (any model) and Mach3 (ex: Operating Manual, User Manual and Setup Manual)
Could you please post them under this thread or post a link to them it would be greatly appreciated.
Hope this helps.
Also found these links very useful
Thank you to Paul Campbell for posting on YOUTUBE
https://www.youtube.com/channel/UCC7...8SYmNgRI0AJqyg
Similar Threads:
Last edited by guslam52; 09-14-2016 at 01:30 PM.
Thank you for taking the time to post this. I bought one of these machines recently and have had no way to verify if the settings are correct or not. Im going to reference your settings when im trouble shooting. Thank you again