Need Help! Enable light won't light up on my KG-4925


Results 1 to 2 of 2

Thread: Enable light won't light up on my KG-4925

  1. #1
    Registered
    Join Date
    Aug 2013
    Posts
    1
    Downloads
    0
    Uploads
    0

    Unhappy Enable light won't light up on my KG-4925

    I have had K2 CNC's KG-4925 for a few years and lightly used it without problems. I always felt it quite reliable until now when the (green) enable light (next to the big red emergency push button) doesn't light up and therefore I could not get the CNC to move at all.

    I know very little about how the setup was or the KMotion codes. I always just followed the simple operating instruction given at the time of purchase. So I do not know how to locate the problem (hardware or software) or where to start looking for assistance. Anyone could advise or help? I am in Northern California. Thanks.

    Similar Threads:


  2. #2

    Default

    Give us a call we can likely help cncrepair.us 9494285079



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Enable light won't light up on my KG-4925

Enable light won't light up on my KG-4925