- Need Help!- Enable light won't light up on my KG-4925
-
Registered
Enable light won't light up on my KG-4925
I have had K2 CNC's KG-4925 for a few years and lightly used it without problems. I always felt it quite reliable until now when the (green) enable light (next to the big red emergency push button) doesn't light up and therefore I could not get the CNC to move at all.
I know very little about how the setup was or the KMotion codes. I always just followed the simple operating instruction given at the time of purchase. So I do not know how to locate the problem (hardware or software) or where to start looking for assistance. Anyone could advise or help? I am in Northern California. Thanks.
Similar Threads:
-
-
Registered
Give us a call we can likely help cncrepair.us 9494285079
- Need Help!- Enable light won't light up on my KG-4925
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules