| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-31-2007, 10:04 AM
| |||
| |||
For those using Joe's 2006 machine and the Hobbycnc stepper motors . In the Mach3 configuration tutorial the motor speed and accelkeration levels can be varied [optimized]. Having no experience at all in this area I was wondering if any members have suggestions or perhaps levels they have found to be acceptable for good machine operation...mike hide.  |
|
#2
12-31-2007, 04:58 PM
| ||||
| ||||
| what leadscrews? I usually cut at 60 to 80 and accel. of 15 on the 2006 |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Calculating acceleration rates | mcmmach | General CNC (Mill and Lathe) Control Software (NC) | 4 | 07-26-2010 07:55 AM |
| Acceleration/plasma? | KKamel | CNC Plasma and Waterjet Machines | 2 | 03-03-2007 04:03 AM |
| acceleration in curves | Antonio_Latron | TurboCNC | 0 | 09-29-2006 10:12 AM |
| acceleration | Iron Brew | CNC Plasma and Waterjet Machines | 0 | 02-18-2005 09:52 PM |
| Acceleration | Photon | DIY-CNC Router Table Machines | 5 | 06-03-2004 12:46 AM |
| | |
Linear Mode
