Questions on Z Carriage - CNCzone.com-The Largest Machinist Community on the net!

Goran321 · #1 12-18-2007, 04:18 PM

I was just curious about 1 things on this jig. I have marked them A, B, and C on the attached picture. How do you cut a hex in C? Is this a two part deal that was glued or was it done on the EDM?

joecnc2006 · #2 12-18-2007, 08:49 PM

Originally Posted by Goran321

I was just curious about 1 things on this jig. I have marked them A, B, and C on the attached picture. How do you cut a hex in C? Is this a two part deal that was glued or was it done on the EDM?

Machined on the cnc.

Goran321 · #3 12-19-2007, 01:28 PM

Joecnc2006,

I was trying to send you a PM but your box is full. Are you still able to provide kits and/or plastic pcs.?

Thanks

joecnc2006 · #4 12-19-2007, 08:21 PM

Originally Posted by Goran321

Joecnc2006,

I was trying to send you a PM but your box is full. Are you still able to provide kits and/or plastic pcs.?

Thanks

Its better to e-mail, the messages here get full quick.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
cleaning up carriage casting	guynamedbathgat	Mini Lathe	7	01-02-2008 07:03 PM
Looking to link the carriage to the headstock spindle	MR.20C	Wood Lathes / Mills	17	10-21-2007 09:39 PM
Building a Solid Carriage Stop for my Lathe!	widgitmaster	Vertical Mill, Lathe Project Log	22	10-29-2006 08:13 PM
Check Carriage Sensor or VC Motor	jstovall	Printing, Scanners, Vinyl cutting and Plotters	1	10-16-2006 07:52 PM
Rails to bearings to carriage to... drive system?	Losos	DIY-CNC Router Table Machines	2	01-11-2005 12:40 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)