| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-02-2007, 09:37 PM
| |||
| |||
Any one know this? I am building the 2006, and I downloaded the DXF files. In the motor support wall drawing it shows 4 1/8" holes in the 4 corners of the part, but they are only .125 in from the ends so that when you drill them, the drill comes out the side of the part. Am I missing something? Walt  |
|
#2
12-02-2007, 10:42 PM
| ||||
| ||||
| I responded to the yahoo group also. Those are my tap marks, so when i have the stanging on the edge in the drill press, i can visually see where to drill and tap. its just a guide. Joe |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Curved Text, vertical walls? | zcases | Vectric | 0 | 04-21-2007 10:29 AM |
| Steel thickness for slats and water tray walls | DeviousMW | CNC Plasma and Waterjet Machines | 4 | 03-15-2007 03:26 PM |
| panalized walls & cnc ? | ken12939 | Commercial CNC Wood Routers | 0 | 01-06-2007 11:45 PM |
| APT Support | cimlinc | General CNC (Mill and Lathe) Control Software (NC) | 0 | 10-24-2006 12:01 PM |
| Stepper motor as end support | DJ Morrow | DIY-CNC Router Table Machines | 1 | 03-15-2004 07:48 AM |
| | |
Linear Mode
