| | |
Hey all... I'm looking at a couple prebuilt Joe's and wanted to get some additional feedback besides the actual details on the specs I'm finding.
Here are the two to compare:
CNC Machine powered by a HobbyCNC board with 305oz steppers in all axis (X, Y, Z)
Hitachi M12VC 2.25 HP Router
Sony Computer system and Monitor to drive the Stepper Board
5-Start drive shaft in X-axis with precision Anti-Backlash leadnuts on all axis.
vs.
1/2 10 Acme lead screws all three axis
CNCRouterParts and dumpsterCNC - anti-backlash solutions for home and industrial linear motion anti backlash nuts
Nema 23 495oz in stepper motors, KL- 4875 power supply, and 5056 drivers from www.kelinginc.net
CNC4PC.com C10 breakout board
Hitachi M12VC 2 1/4HP Router
3 Home Switches
Dell P2 desktop and monitor running EMC2 all setup
Last edited by ger21; 05-04-2012 at 11:47 AM.
The one with 5 start screws should be 3-5 times faster.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Posting Permissions
| | |
LinkBack URL
About LinkBacks
