Hey, everyone. I've got the wrong mounting block for the Dumpster CNC nuts I have for my 2006. Does anyone have a set of three or is anybody willing and able to cut them out of HDPE for me? I'll pay! I've tried emailing Joe a few times, but haven't heard a thing. Can someone help? The pic is what I have now...
Sorry I did not see an e-mail, I get allot of email everyday as you could imagine, and spam do not even get me stated..
But what you could do Is flip the HDPE block over, and enlarge the center hole so the Anti-Backlash nut will fit through it then mark the holes for the flange on the HDPE and drill through the block and use 1" screw/lock nuts to fasten the Anti-backlash nut to the block and when mounting face the flange to the MDF side and tighten to the Carriage, The screws will slightly embed into the MDF and will not move.
joecnc2006 at yahoo