For Sale Joe2006CNC Visalia,California

[calgrdnr]

Well I got my Shopbot

I need some room in the garage . My Joes2006CNC is now up for sale. It will include PC, 19 inch crt, Controller, Hitachi Router , T tracks 5 start screws. can cut at 150ipm and rapids at 320 ipm . pictures @
Kents Joes2006CNC for sale - a set on Flickr

I will also include Aspire 2.5 and PhotoVcarve ( you will need to pay licence transfer fee to Vectric)

I ran this machine with Mach3. The license for Mach3 is non transferable. so you will need to either buy Mach3 or use different controller software.

This is a great little machine and to tell the truth if I had the room I would keep it.

I am asking 2500.00 for all mentioned above . I am firm on price. If I can not sell it for this price. I will sell Aspire and PhotoVcarve separate and dismantle for future use

Thanks for looking you can email me at calgrdnr "at" sbcglobal.net with any questions


thanks Kent

My build thread Joe's 2006 CNC in Visalia,Ca

[calgrdnr]

Thanks for all the inquires


Kent

[cutter100]

Thanks Kent, you built a strong joes and I'm sure going to have a lot of fun with it...

Chris