LinkBack URL
About LinkBacksI drew/cut a straight line with my pen connected to my machine. I was supposed to be 127mm. When measured it is really approx 162mm.
Do I need to adjust a ratio somewhere within Mach3?
Thank You
I drew/cut a straight line with my pen connected to my machine. I was supposed to be 127mm. When measured it is really approx 162mm.
Do I need to adjust a ratio somewhere within Mach3?
Thank You
steps/unit in motor tuning
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Howdy Ezra Just got your PM I replied back at you .
sorry bout the delay was just signed in today ...
Sound like you have a lot done . Where are the pictures ?
Kent
Posting Permissions
