Double Nuts on Both Ends? - CNCzone.com-The Largest Machinist Community on the net!

Ezra · #1 11-08-2010, 06:37 PM

Do I put double nuts on both ends of the lead screws or just the end opposite side of the motor?

I have it all assembled and ready to go.

Firen it up tommorow

nego_0 · #2 11-13-2010, 08:00 AM

Both ends. unless you get the nice nut locker thingy from dumpster cnc.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GMT Ballscrews + Poll: Double vs. Single Nuts	Glacern	Linear and Rotary Motion	4	12-05-2009 11:15 AM
leadscrew nuts and half nuts	jayhawkman	EBAY ADS	0	11-07-2009 01:00 AM
My T-nuts are just slightly too big for my table. Do I mill table or T-nuts?	slashmaster	Benchtop Machines	7	06-04-2009 07:34 AM
Nuts are driving me nuts!	Cold Fusion	CNCzone Club House	9	06-12-2004 11:40 PM
Nuts; I'm thinking about my nuts	Stevie	General Metal Working Machines	11	02-28-2004 05:55 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)