| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| JGRO Router Table Design For the discussion of JGRO designed router table. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-13-2008, 04:29 PM
| |||
| |||
well i finally got those motors. took me a long time but worth the wait. i still got to get some bits and do some fine tuning.got to say thanks to all those members who submitted their knowledge on this forum. thanks to jason and tajord for their input. I must say i had a good time soldering the board.here is a clip of the machine cutting a circle. came out okay although i am a 1/16 out i believe the bit is worn so i will wait until i get some new ones. the bed is sagged a little i guess from being there so long so i plan to change it. any one has any vaccum plans? I am getting problems uploading the file will upload when i figure out the problem.  |
|
#2
11-13-2008, 05:07 PM
| |||
| |||
| Congrats, off and running. Jason |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone out there running there car on CNG | austin.mn | CNCzone Club House | 8 | 06-14-2008 01:11 PM |
| It's RUNNING! | TCGliderguy | Super Tech Controllers, SuperCam & SuperCamXp | 3 | 03-15-2008 08:34 PM |
| Running hot, really, really hot | imagineer | Stepper Motors and Drives | 10 | 01-18-2007 08:51 AM |
| Can't get EMC running | borrisl | LinuxCNC (formerly EMC2) | 2 | 08-18-2006 02:58 PM |
| Up and running! | maxxgraphix | DIY-CNC Router Table Machines | 5 | 03-16-2005 07:10 AM |
| | |
Linear Mode
