up and running

[clammy23]

well i finally got those motors. took me a long time but worth the wait. i still got to get some bits and do some fine tuning.got to say thanks to all those members who submitted their knowledge on this forum. thanks to jason and tajord for their input.
I must say i had a good time soldering the board.here is a clip of the machine cutting a circle. came out okay although i am a 1/16 out i believe the bit is worn so i will wait until i get some new ones. the bed is sagged a little i guess from being there so long so i plan to change it. any one has any vaccum plans? I am getting problems uploading the file will upload when i figure out the problem.

[Jason Marsha]

Congrats, off and running.

Jason