my jgro

[cute_dorkie]

hello everyone om kinda new here ind im trying to build the jgro its kinda hard when u dont know anything about decimals so i think the mesurments are kinda off im looking for bearings and aluminum angle iron....not really that many places around here that sell bearings cept sporting good stores but we dont have any close to me....saw some on ebay but i dont know if those are any good? ohh what type of motors do i need? my brother wants me to cut stuff outta aluminum for him dont know if the machine can do that? all i've seen it cut is wood but i just want it to make pcb boards....well this is what i have so far took some pictures with my phone hope there clear ok i think my pictures were added we'll see when i post this

[cute_dorkie]

hmmmm i added more lol guess they didnt all add lol...i have another question in the jgro plans i dont get how to make the clamp things for the router i'll post more pictures here see if they work

[Glidergider]

Here's what I did for the router mounts.
http://www.cnczone.com/forums/showth...=30935&page=10
Post 112.

[cute_dorkie]

thank you for the reply pictures look good i dont have any of that type of material for the mounts well i do but its not that thick its only 1/2" thick but maybe it will work its an old cutting board i have.... i was looking at my gantry pictures and pictures of other people's and my tubes look off if they are is there a way i can fix them? i dont have anymore mdf to cut anymore pieces