question about it's capabilities

[Twin-X]

Hello,

Is the JGRO build good enough to engrave / cut 3mm thick aluminum panels?
I need to build something for the engraving of enclosures but i have 0 experience.

I wonder if this machine can handle it or maybe it's too powerfull?
1 thing is sure it's very big for the panels i wish to engrave / cut.

Regards,
Jeffry

[Jason Marsha]

A well built JGRO can engrave aluminium with no problems, you must however appreciate that the machine is constructed from MDF so you will have to cut more slowly than if the machine was one of metal construction.

Jason

[Twin-X]

A well built JGRO can engrave aluminium with no problems, you must however appreciate that the machine is constructed from MDF so you will have to cut more slowly than if the machine was one of metal construction.

Jason

Well i am not going to use it for mass production anyway.
Thank you for the info!

[ifeliciano]

A well built JGRO can engrave aluminium with no problems, you must however appreciate that the machine is constructed from MDF so you will have to cut more slowly than if the machine was one of metal construction.

Jason

So if one would build it from a marine grade Baltic Birch. could the cut rate be higher vs. MDF ?

[Coogrrr]

So if one would build it from a marine grade Baltic Birch. could the cut rate be higher vs. MDF ?

or what about HDPE?

[Jason Marsha]

I suspect the rate is about the same.

Jason