Introduction and a question

[excotec]

Hello all. I am Jay from Ohio. Been lurking on this site on and off for a year or so. I had planned on building a Glen-L boat this winter but it looks like I may be moving back to Germany Next year. Not sure how hard it would be to take a boat so figured this would be something I could take instead. I have wanted to build one for a while and would eventualy like to buld a wooden clock with it. Will most likely go with the hobbycnc package as it seams to get good reviews.

Now for my question.....

I drive a honda civic and there is no way I can fit a sheet of mdf in there. Dont think I could even squeeze a 4x4 sheet in there. I see at menards I can get a 2x4 sheet though and that would fit. Anybody have the cutlist for a 2x4 sheet of mdf?

Thanks

[kbisswanger]

I don't have a cut list, but I did build a JGRO. I also built a wooden clock using the machine. Very capable little machine. Best of luck. I added a few pictures for inspiration.

[excotec]

Thanks. I have managed to get the cut list down to the size I need and have purchased the wood. Just need to find time now. Long work hours keep getting in my way of fun.