JGRO Build - CNCzone.com-The Largest Machinist Community on the net!

Build · #1 05-23-2011, 08:53 AM

I've just got my JGRO build to the point that all 3 axis move and there's a bed to work against.

So, I mounted a piece of paper and a pencil and proceeded to draw stuff from Mach3.

This is my first CNC build and went fairly well despite the constant translations to metric. I wanted to widen the bed as well as lengthen it but I got lost somewhere between the planning and the saw and ended up still cutting it about 600 wide.

Thanks very much for making the design available and so easy to build. I'll post photos when I get time to reduce them to fit in the forum limits.

Tom_M · #2 05-25-2011, 06:12 PM

Interested in seeing your photos. I'm on the same trail. I just got the electronics/motors working, ordered some Acme screws and nuts and bearings. I should be cutting wood this weekend.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
09-07 jgro build	CNC-Dad	JGRO Router Table Design	3	02-22-2012 09:23 PM
Jgro cnc build Log	tbenefi33	JGRO Router Table Design	54	10-19-2010 03:17 PM
New JGRO build	gylron	JGRO Router Table Design	9	07-09-2008 06:43 AM
My JGRO build	Sieg	JGRO Router Table Design	46	10-31-2007 08:36 AM
going to build the jgro	clammy23	DIY-CNC Router Table Machines	0	01-04-2007 05:44 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)