Has anyone made the jgro from plywood? - CNCzone.com-The Largest Machinist Community on the net!

Markwind · #1 10-14-2010, 05:28 AM

Has anyone made the jgro from plywood?
thks Mark

DeadTom · #2 10-14-2010, 12:51 PM

Mark,
Yes, I have seen in this JGRO thread machines made out of plywood (mostly baltic birch plywood). What type/size were you thinking of?
Tom

Markwind · #3 10-15-2010, 06:23 AM

Not sure about size or design at this point. but I really was interested in using plywood, got lot's of it, and at the same time worried about it being to uneven

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
JGRO parts made if you have access to a manual mill	nearbeer	JGRO Router Table Design	2	09-15-2010 01:03 PM
MDF vs Plywood	Lurkepus	JGRO Router Table Design	3	10-08-2008 06:19 AM
best plywood	beamer	Laser Engraving & Cutting Machines	6	08-06-2007 05:27 PM
Made in Australia (Made in taiwan, china)	carbidecraters	General Metalwork Discussion	0	01-10-2006 02:05 PM
Home made CNC mill (and some products made by it)	gcamlibel	DIY-CNC Router Table Machines	23	04-05-2004 05:54 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)