| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Industrial Hobbies (Support forum) Discuss Industrial Hobbies Milling machines and get direct support here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-02-2009, 03:26 PM
| |||
| |||
I'm using a ShuttlePro Ver. 2 jog controller. What controls the speed at which the table moves when you rotate the dial in the center of the ShuttlePro? I don't see any field for this in the configuration screen. Neither does the Mach3 Feed Rate control seem to have any effect. The table moves too slowly and I want to speed it up.    |
|
#2
10-02-2009, 05:51 PM
| ||||
| ||||
| Using the center wheel to control speed is not a good idea with this pendant, it's too picky to maintain a constant speed, and too slow to react to changing speeds. You can try it by changing the Mach3 jog mode to continuous. I use the center wheel to move definate steps, like .001 for positioning the spindle, and the outer wheel has 4 or 5 detents that I use to moving the spindle at constant speeds for manual milling. This setup works great. Paul |
|
| Tags |
| jog controller, shuttlepro |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carriage Wheel | bling59 | General Metalwork Discussion | 3 | 06-16-2009 11:57 AM |
| Using a Shuttlepro as a pendant? | johnmac | Mach Software (ArtSoft software) | 20 | 05-13-2009 11:28 PM |
| Need Help!- Using a Shuttlepro with Mach3 | johnmac | Mach Software (ArtSoft software) | 6 | 05-04-2009 07:42 PM |
| MPG jog wheel | The Blight | TurboCNC | 6 | 06-12-2008 03:19 PM |
| Mach3 and ShuttlePro 2 Help | tullsnr | Mach Wizards, Macros, & Addons | 1 | 11-01-2007 06:26 AM |
| | |
Linear Mode
