| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Industrial Hobbies (Support forum) Discuss Industrial Hobbies Milling machines and get direct support here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-17-2007, 10:09 PM
| |||
| |||
The mill developed a bad noise (I thought maybe the bearings in the motor) so I pulled the motor and had it sitting on the top of the mill running to see If I could get it to make the same noise without the load on the gear train. Well my wife called for some help and the darn motor vibrated off and pulled the wires out of the motor starter control box. I have it back together but have no idea which wires go where. I have a wiring diagram from Enco but the colors are not correct or all shown. Any ideas? David Munson  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wiring help | watsonstudios | Automation Technology Products | 4 | 06-12-2007 11:32 PM |
| need help wiring | dtman | CNC Plasma and Waterjet Machines | 11 | 02-19-2007 07:55 AM |
| wiring it all together | russell | General Electronics Discussion | 2 | 08-22-2006 09:08 AM |
| CNC wiring? | stdly | General Electronics Discussion | 11 | 02-18-2006 02:44 PM |
| P5 Wiring | tintruder | Servo Drives | 2 | 02-03-2006 11:13 AM |
| | |
Linear Mode
