Results 1 to 7 of 7

Thread: support address for IH

  1. #1
    Registered
    Join Date
    Nov 2006
    Location
    U.S.A.
    Posts
    12
    Downloads
    0
    Uploads
    0

    support address for IH

    I sent an email to IH a couple of weeks ago, I sent it to Support@IndustrialHobbies.com. I haven't heard anything back from them and was wondering if I used the wrong address to get a hold of them. What adress should I use to contact IH for a customer support question?

    -brian


  2. #2
    Registered
    Join Date
    Mar 2006
    Location
    USA
    Posts
    158
    Downloads
    0
    Uploads
    0

    Try again

    They were going through ownership changes then. I'm sure if you tried it again now, you will have better luck.


  3. #3
    Registered
    Join Date
    Nov 2006
    Location
    USA
    Posts
    33
    Downloads
    0
    Uploads
    0
    I have sent them e-mails in the past also and gotten no replies. You might try calling them. Just a suggestion.


  4. #4
    Registered
    Join Date
    Nov 2006
    Location
    U.S.A.
    Posts
    12
    Downloads
    0
    Uploads
    0
    Speeder,

    Did you get a response when you called?

    -brian


  • #5
    Registered
    Join Date
    Nov 2006
    Location
    USA
    Posts
    33
    Downloads
    0
    Uploads
    0
    Been awhile. Got answering machine. Still no call back. Just got left hangin.


  • #6
    Registered
    Join Date
    Mar 2006
    Location
    USA
    Posts
    158
    Downloads
    0
    Uploads
    0

    Please contact me

    Please contact me in regards to this matter. You can call 717-505-8638.


  • #7
    Registered
    Join Date
    May 2005
    Location
    usa
    Posts
    80
    Downloads
    0
    Uploads
    0
    Give them a call and leave a VM, they will call back.


  • Similar Threads

    1. Macro alarm "009 ILLEGAL ADDRESS INPUT"
      By theemudracer in forum Fanuc
      Replies: 7
      Last Post: 12-26-2006, 10:57 AM
    2. Email Address Pitfalls
      By widgitmaster in forum Computers and Networking
      Replies: 1
      Last Post: 12-14-2006, 08:14 AM
    3. APT Support
      By cimlinc in forum General CNC (Mill and Lathe) Control Software (NC)
      Replies: 0
      Last Post: 10-24-2006, 01:01 PM
    4. Update your email address!
      By CNCadmin in forum CNCzone Site News and Contests
      Replies: 0
      Last Post: 04-13-2004, 02:02 PM

    Posting Permissions


     


    About CNCzone.com

      We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

    Follow us on

    Facebook Dribbble RSS Feed


    Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.