Results 1 to 2 of 2

Thread: new turnkey setup questions

  1. #1
    Registered
    Join Date
    May 2006
    Location
    usa
    Posts
    196
    Downloads
    0
    Uploads
    0

    Red face new turnkey setup questions

    Coming out of the controller box is the 220 cable and also a 110 male and female "extension cord".

    So 110 power in to controller box, whats 110 power out intended for?


  2. #2
    Registered
    Join Date
    Feb 2006
    Location
    usa
    Posts
    779
    Downloads
    0
    Uploads
    0
    It would be my guess that it is for a coolant pump.
    But, in that it is a turn key then I would advise calling tommy and asking for his input for sure.
    Don
    IH v-3 early model owner


Similar Threads

  1. questions regarding a Teco N3 setup
    By cruzin in forum CNCzone Club House
    Replies: 0
    Last Post: 10-12-2010, 05:40 PM
  2. Need Help!- Syil X4 setup questions
    By mikie in forum Syil Products
    Replies: 9
    Last Post: 06-15-2009, 02:11 AM
  3. Setup problems & Questions
    By tvdbon in forum Mach Software (ArtSoft software)
    Replies: 1
    Last Post: 12-11-2007, 11:20 AM
  4. More Mach3 Setup Questions
    By bill south in forum Mach Mill
    Replies: 2
    Last Post: 05-08-2006, 11:10 AM
  5. Setup Questions
    By WarrenW in forum SheetCam
    Replies: 1
    Last Post: 01-31-2006, 04:01 AM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.