I'm using a ShuttlePro Ver. 2 jog controller. What controls the speed at which the table moves when you rotate the dial in the center of the ShuttlePro? I don't see any field for this in the configuration screen. Neither does the Mach3 Feed Rate control seem to have any effect. The table moves too slowly and I want to speed it up.
Using the center wheel to control speed is not a good idea with this pendant, it's too picky to maintain a constant speed, and too slow to react to changing speeds. You can try it by changing the Mach3 jog mode to continuous.
I use the center wheel to move definate steps, like .001 for positioning the spindle, and the outer wheel has 4 or 5 detents that I use to moving the spindle at constant speeds for manual milling. This setup works great.