MACH 3 Spindle speed input - CNCzone.com-The Largest Machinist Community on the net!

12-31-2008, 06:10 PM

billyfriday billyfriday is offline

Join Date: Dec 2008

Location: wales (uk)

Posts: 9

MACH 3 Spindle speed input

I have just converted my ML7 and am stuck on how i go about sending mach 3 the spindle rpm so i can screw cut.
iI have a proximity switch but where on the breakout board do i wire it?

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
analog input VFD speed Hitachi SJ100	Karl_T	Phase Converters and VFD	10	11-22-2008 04:09 PM
Problem- Syil X3 Erratic Spindle Speed with Mach	reithguitars	Syil Products	9	07-16-2008 11:20 AM
how to measeure spindle speed with mach	markus_detroy	DIY-CNC Router Table Machines	1	05-11-2008 06:21 PM
MACH 3 USB INPUT CONFIGURATION	coremfg	Machines running Mach Software	5	01-08-2008 09:04 AM
How Mach 3 handles spindle speed	jderou	Mach Software (ArtSoft software)	3	09-19-2005 08:22 AM

All times are GMT -5. The time now is 09:31 PM.