| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| I.C. Engines Discuss home made Internal Combustion engines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-07-2011, 04:47 PM
| |||
| |||
Hi Guys Not to sure if this is the correct place for this question, but here goes. If you where designing a Vacuum Engine (Flame Sucker) using a 4.5" Flywheel with a face width of 1/2" wide (Cast Iron) what Bore & Stroke would you use? I was guessing at a 1" Bore and 1.5" Stroke? Interested to here your thoughts on this subject? Thanks for your help. Cheers Willy  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie- Design questions | elz | DIY-CNC Router Table Machines | 6 | 04-20-2009 10:37 PM |
| Looking for a dust sucker. | kevperro | Joes CNC Model 2006 | 8 | 05-27-2008 11:42 AM |
| MCX Design questions | Shotout | Mastercam | 5 | 04-02-2007 11:30 AM |
| Design Questions | hani_a | General Electronics Discussion | 1 | 07-21-2006 02:45 PM |
| Scratch Design Questions | danowar | DIY-CNC Router Table Machines | 7 | 12-30-2003 04:16 PM |
| | |
Linear Mode
