| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hyundai Kia machine Discuss hyundai kia machine here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-26-2009, 12:00 PM
| |||
| |||
| Alarm 410 and 414 fanuc 18mc Good evening, friends I have the following problem when I move my vertical axis horizontal machining center, makes a noise as if hitting metal to metal, it is strange that sometimes leaves is not constant. Fanuc 18mc is a control, and the series of servomotor is A06B-0148-B177 After the noise, see the "LOAD METER" on that axis is in more than 200%, the alarm goes 414    |
|
#2
03-26-2009, 02:04 PM
| |||
| |||
| Sound like the ballscrew end bearing defective, you should remove the servo motor of the ballscrew and just run the motor only, if noise go away then possible the end bearing. Ahn Vuong |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fanuc 18MC Question | swartling | Fanuc | 4 | 05-03-2011 02:04 PM |
| Need Help!- Need file Fanuc 18Mc Nc-basic | Osmanselim | Fanuc | 4 | 02-25-2009 12:00 AM |
| Wintec MV-45 with FANUC 18MC needs ATC Macro program | hrh | Fanuc | 4 | 01-12-2009 02:33 PM |
| RISK 64 on Fanuc-18MC Controller | iNUC | Fanuc | 0 | 09-21-2008 04:38 AM |
| Large PartPrograms on Fanuc 18MC,how to | ddanutz | Fanuc | 6 | 10-30-2006 01:05 PM |
| | |
Linear Mode
