KIA LATHE SKT21LMS FANUC IO-TC G75 CAN CYCLE NEED DWELL HELP

[plast744]

hi we have a kia lathe 21lms fanuc io-tc

we using CAN cycle for grooving G75 and need a dewell on the bottom of the groove
(groove botton x96. metric.)
ex:
X100.
G75 R7.
G75 X96.7 Z259.625 P1500 Q 0775 R0 F.1
( Z259.625 =PITCH Q.775MM )
i try to put a dewell BEFORE AND after the
G75 R.7
G04 P3000 AND IT NOT WORKING
any sugestiong thanx

Similar Threads:

• NEED HELP ON SKT21LMS LATHE M CODE SUBSPINDLE TAP
• Dwell With Pecking Cycle?
• Need Help!- programing a dwell cycle
• Newbie- programing a dwell cycle

[OkumaWiz]

Have you tried to use the X command rather than the P?

Best regards,

[plast744]

what do you mean X command

replace P for as X
can't cause i already have X96.7 2 X can't be on the same line

[OkumaWiz]

I meant try the G04 X3.0 for 3 second dwell.

Best regards,

[plast744]

not working i think the dwell have to be on the same line of G75 X96.7 Z259.625 P1500 Q 0775 R0 F.1

[OkumaWiz]

I do not believe that the G75 cycle has the ability to add a dwell in the cycle.

Some of the other cycles such as G83 have the ability but are typically used for drilling.