Hypertherm CNC Interface Cable

[rideright]

I have a Powermax 45 and would like to make a Interface Cable for it. Dose any one know what type connector I need to make one.

[jimcolt]

The connector is made by Amp Tyco Electronics, it consists of a Connector body, a cable clamp and the appropriate number of pins. Here are the manufacturers part numbers.....I purchase them through Allied Electronics Allied Electronics

Connector body 206044-1 Hypertherm # 008202
Cable Clamp 206070-8 Hypertherm # 008192
Contact pin, crimp type 1-66099-5 Hypertherm # 008176

The toughest part is that the pins for these plugs require a special crimping tool.


The cable from Hypertherm (25' long) is # 123966


Jim Colt

I have a Powermax 45 and would like to make a Interface Cable for it. Dose any one know what type connector I need to make one.