| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hypertherm Plasma Discuss hypertherm plasma machines here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-12-2011, 10:07 AM
| |||
| |||
Was curious if anyone had some good settings for copper on a Hypertherm HSD130? I have found the 45A Aluminum setting seems to work ok for the thinner stuff but it does leave a little more dross than I would like although I fear this may be unavoidable. Any suggestions would be greatly appreciated. Thanks.  |
|
#2
12-13-2011, 04:22 AM
| |||
| |||
| You are on the right track following the aluminum cutting specs. Copper absorbs a tremendous amount of the heat from the process. Maximum thickness for an HPR130 with decent quality will likely be in the 1/4" range. Jim Colt |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2011 CNC Plasma Cutting, Water Table, HSD130 Oxygen | CNCadmin | EBAY ADS | 0 | 08-27-2011 11:00 PM |
| 2011 CNC Plasma Cutting, Water Table, HSD130 Oxygen | CNCadmin | EBAY ADS | 0 | 07-05-2011 01:30 PM |
| 2011 CNC Plasma Cutting, Water Table, HSD130 Oxygen | CNCadmin | EBAY ADS | 0 | 06-15-2011 05:40 PM |
| 2011 CNC Plasma Cutting, Water Table, HSD130 Oxygen | CNCadmin | EBAY ADS | 0 | 06-02-2011 09:00 PM |
| 2011 CNC Plasma Cutting, Water Table, HSD130 Oxygen | CNCadmin | EBAY ADS | 0 | 03-19-2011 09:16 PM |
| | |
Linear Mode
