| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hypertherm Plasma Discuss hypertherm plasma machines here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-30-2011, 11:30 AM
| ||||
| ||||
Jim, I am looking for a settings chart for fine cut consumables for my PowerMax 600 hand torch used on a CNC table. I found the chart for the standard 40 amp consumables in the manual, but would like to fine tune for the fine cut consumables. Thanks, Joe  |
|
#2
12-01-2011, 07:41 AM
| |||
| |||
| Joe, Since most of the Powermax600's were built before there were any finecut consumables...the cut chart was not included in the operator manual. If you want to contact my direct email...I will send you the .pdf copy of the original FineCut brochure...which has the cut specs for all thicknesses for use with the Powermax600. jim.colt@hypertherm.com You can also download any Hypertherm document directly from the Hypertherm | Plasma Cutters | Plasma Cutting Equipment | Metal Cutting Equipment website. click on "download library", then choose Powermax600, then either fine cut brochure or cut charts, then download it as a .pdf. Look forward to hearing from you, best regards, Jim |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Kerk Chart | Stout | Hypertherm Plasma | 2 | 03-27-2011 07:46 AM |
| comparator chart | jas6142 | Calibration & Measurement | 0 | 02-06-2008 04:13 PM |
| chart on threads | DONNYBRASS | General Metalwork Discussion | 7 | 12-12-2007 05:47 PM |
| Comparison Chart | BJR | Benchtop Machines | 0 | 08-03-2007 04:04 PM |
| Comparison Chart | BJR | Benchtop Machines | 0 | 08-03-2007 04:00 PM |
| | |
Fine cut chart for Powermax 600 
Linear Mode
